Desoldering Wick Braid, 9.8-82 Foot No-Clean Copper Solder Remover with 0.1-Inch Fine Weave Options

This desoldering wick braid uses tightly woven pure copper to pull excess molten solder from PCB pads, component leads and wire joints. Its flat fine-weave construction conducts heat quickly and strengthens capillary action, helping technicians clear a connection neatly during repair, component removal or correction of a solder bridge.

Choose single-roll lengths of approximately 9.8, 49.21 or 82 feet, plus listed two-roll and three-roll configurations. The documented wick is about 0.1 inch wide and treated for no-clean solder removal. Position a fresh section over the joint, heat through the braid until solder flows into it and lift the wick and iron together before the solder cools. Cut away the saturated section and avoid pulling on a solidified joint.

Specifications

• Product: Desoldering wick braid
• Material: 100% copper wire
• Documented width: 0.1 inch
• Length options: 9.8 49.21 or 82 feet
• Pack options: 1 2 or 3 rolls
• Treatment: No-clean flux listed
• Weave: Flat fine-braid construction
• Action: Capillary solder absorption
• Uses: PCB pads leads and wire joints
• Operation: Heat through braid and trim used section